APC BR1500MS2 vs BX1500M

Pay the extra for the BR1500MS2 if a desktop PC with an active PFC power supply will run on it, which covers almost every modern desktop. Buy the BX1500M for routers, modems, laptops and older PCs. The two share a 900 W rating, a 16 hour recharge and an 8 ms transfer. But the BR also runs about a third longer at the same 450 W load.

On this page
  1. Three terms the choice turns on
  2. The spec sheets side by side
  3. The runtime gap nobody mentions
  4. What the price gap actually is
  5. Worked example: one gaming PC on each unit
  6. When the BX1500M is enough
  7. Is the bigger equipment policy worth paying for?
  8. Decision table
  9. What this comparison does not cover
  10. Frequently asked questions

The BR1500MS2 is worth the extra money if an active PFC desktop will run on its battery. For anything else, the BX1500M does the job. That much matches the usual advice. What the usual advice leaves out is runtime. At the same 450 W load, the BR1500MS2 runs 14.5 minutes and the BX1500M runs 10.9.

So the common framing is close but not complete. The watts, the recharge time and the transfer time are the same on both sheets. The waveform and the size of the equipment policy differ, as people say. But the extra money also buys about a third more runtime, two USB charging ports and one more battery outlet.

Three terms the choice turns on

Sine wave vs stepped wave. Wall power is a smooth curve. On battery, the BR1500MS2 makes a smooth curve too. APC's sheet for the BX1500M calls its battery output a "stepped approximation to a sinewave." That means the voltage jumps up, holds flat, drops to zero and jumps the other way. The average is right but the shape is not. Our guide to pure sine vs simulated sine shows both shapes side by side.

Active PFC. Active power factor correction is a circuit at the front of a computer power supply. It makes the supply draw current smoothly, in step with the voltage. Its control loop expects a sine wave, so when it is fed a stepped wave, some supplies shut off, buzz, or make the UPS report an overload. Not all do, and the risk rises with load. Our page on active PFC power supplies covers how to spot one. The short version: an 80 PLUS badge means active PFC.

Equipment protection policy. This is APC's promise to pay for gear damaged by an electrical event that passes through the UPS. The dollar amount is the most it will pay, not a sum anyone receives. It is separate from the 3 year warranty on the UPS itself.

The spec sheets side by side

These figures come from APC's own datasheets, except where the table says otherwise. APC's sheets for these two models do not print runtime minutes. Those come from reseller spec listings, and both are timed at half load, which is 450 W on a 900 W unit.

APC BR1500MS2 vs BX1500M (APC datasheets unless noted)
SpecBR1500MS2BX1500M
Rating1500 VA / 900 W1500 VA / 900 W
TopologyLine-interactiveLine-interactive
Waveform on batterySine waveStepped approximation to a sinewave
Runtime at 450 W (reseller listings)14.5 min10.9 min
Transfer time8 ms typical, 10 ms max8 ms typical, 10 ms max
Typical recharge time16 h16 h
Charger power16 W11 W
Outlets (battery + surge only)6 + 45 + 5
USB charging portsUSB-A + USB-CNone
Surge energy rating1080 J789 J
Replacement batteryAPCRBC163 (reseller listing)APCRBC124
Weight27.6 lb24.3 lb
Warranty3 years repair or replace3 years repair or replace
Equipment protection policyLifetime, $500,000Lifetime, $250,000

Transfer time is the gap between wall power failing and the battery taking over. A desktop power supply rides through 8 to 10 ms on its own stored charge, so this tie costs nothing. See UPS transfer time for why that range is normal for line-interactive units. Both sheets list a multi-function LCD. Schneider's current BX1500M product page calls it an LED display, so check the box if the screen matters to you.

The runtime gap nobody mentions

Most comparisons stop at "same watts, different wave." That makes the units sound like twins with one switch flipped. They are not. The two listings time both units at the very same load, 450 W. That makes the figures a fair match, with no scaling needed. At that load, the BR1500MS2 gives 14.5 minutes and the BX1500M gives 10.9. That is 3.6 minutes more, or about 33%.

The rest of the sheets point the same way. The BR1500MS2 takes a different battery cartridge and is 3.3 lb heavier. APC rates its charger at 16 W against 11 W, yet both need the same 16 hours to refill. A bigger charger taking the same time points to a larger battery. For the BX1500M, APC lists a 24 V 9 Ah cartridge, the APCRBC124. Our page on putting a car battery on a UPS works through what that 16 hour recharge means for a bigger bank on a BX1500M.

Our analysis: the extra money buys three things, not one

Sine wave output is the reason to pay. But the same money also brings about a third more runtime at 450 W and USB-A and USB-C charging. If you would buy the BR1500MS2 for the waveform anyway, the runtime comes free. If you only need runtime, a sine wave is not the cheapest way to get it.

What the price gap actually is

The "about $110" figure comes from sale prices. SmartHomeCompared listed $299.99 for the BR1500MS2 and $189.99 for the BX1500M, a $110 gap. The same page showed regular prices of $339.99 and $249.99. APCGuard, a reseller, lists those same regular prices. At regular prices the gap is $90.

Prices on both models move often, so treat the gap as $90 to $110 and check on the day you buy. Either way, the question is the same: is a sine wave plus 3.6 minutes worth about a hundred dollars for what you plug in?

Worked example: one gaming PC on each unit

Take a gaming PC with an 850 W, 80 PLUS Gold power supply. Suppose it draws about 410 W at the wall while gaming. Add a 40 W monitor, and the battery outlets carry 450 W.

  1. Check for active PFC. The 80 PLUS program requires a power factor of at least 0.9 at full load. In practice only active PFC supplies reach that, so this PC has active PFC.
  2. Apply the waveform rule. An active PFC supply on stepped output is the risky case. That points to the BR1500MS2 before sizing starts.
  3. Check capacity. Our gaming PC sizing guide plans gaming loads at 70% of the watt rating, because GPU spikes do not show on a watt meter. Both units are 900 W, so the limit is 630 W on either. 450 W fits both. Capacity does not decide this one.
  4. Read the runtime. 450 W is exactly the half load both listings use. So the BR1500MS2 gives about 14.5 minutes with fresh batteries, and the BX1500M about 10.9. Both are enough to save and shut down. Neither is enough to keep playing through a long outage.

On this PC, the sine wave is the reason to pay more. The 3.6 extra minutes are a bonus. Now swap the load for a fiber ONT, a router and a mesh node, about 30 W in all. None has active PFC to upset. Here the BX1500M is fine, and the BR1500MS2 buys a smoother wave no device needs.

When the BX1500M is enough

A stepped wave is fine when nothing on the battery outlets has active PFC. In practice that means:

  • Network gear on small adapters: modems, routers, ONTs, switches and VoIP boxes. See UPS for modem and router. A 1500 VA unit is far bigger than that load needs, so a smaller unit may be the better buy.
  • Laptops on their chargers. The laptop's own battery carries it through anything odd in the wave.
  • Older PCs with passive PFC or none. A red 115/230 V switch on the back of the power supply usually marks one of these.

If you already own a BX1500M and an active PFC PC, do not replace it on faith. Put the PC under its usual heavy load, pull the UPS plug from the wall, and watch for a minute. If the PC shuts off, the fix is a sine wave unit. A worn battery can cause the same shutdown, so check the other causes on our page about a UPS that shuts off during an outage first.

Is the bigger equipment policy worth paying for?

No, not on its own. The BR1500MS2 carries a lifetime $500,000 policy and the BX1500M a lifetime $250,000 one. Both are ceilings. A claim pays for damaged gear, usually at repair cost or fair market value, and only if you meet the conditions. Those often include plugging gear straight into the UPS, buying from an authorized seller and keeping proof of purchase. Our guide to UPS warranties and equipment guarantees lists the usual terms.

A home desk rarely holds $250,000 of gear on one UPS, so the higher ceiling seldom changes what a claim would pay. Read the policy for your model before you count on either one.

Decision table

Choosing between the APC BR1500MS2 and BX1500M
What is on the battery outletsPickWhy
Desktop or gaming PC with an 80 PLUS badge or a 100-240 V input and no switchBR1500MS2Active PFC; only the BR makes a sine wave on battery
Load near 450 W and you want the most minutesBR1500MS214.5 min vs 10.9 min at 450 W
Modem, router, ONT, switch on small adaptersBX1500M (or smaller)No active PFC to upset
Laptop on its chargerBX1500MThe laptop battery rides through the wave
Older PC with a 115/230 V switchBX1500MPassive or no PFC
You want to charge a phone or tablet from the UPSBR1500MS2Only it has USB-A and USB-C charging ports
You care about recharge timeEither16 hours typical on both sheets
You want the larger equipment policyNot a reason aloneThe figure is a ceiling with conditions

Bottom line

For any active PFC computer, the BR1500MS2 is worth the $90 to $110. The sine wave is the reason, and the extra runtime comes with it. For network gear, laptops and older PCs, save the money and buy the BX1500M, or something smaller.

What this comparison does not cover

The runtime figures are for new, fully charged batteries, as quoted in reseller listings of APC's specs. APC's own datasheets for these two models do not print them. Real runtime falls as batteries age and in heat, so use our runtime guide for your own load. This page also does not judge how clean either waveform looks on a scope beyond what the sheets state. It does not cover motor loads such as sump pumps or furnace blowers, which have their own rules. Laser printers and space heaters do not belong on the battery outlets of either unit. Prices change weekly, so the gap in this article is a snapshot.

For how these two fit among APC's other families, see the APC lineup guide. CyberPower's matching pair, one sine and one stepped, is in CP1500PFCLCD vs CP1500AVRLCD.

Frequently asked questions

Is the APC BX1500M pure sine wave?

No. APC's BX1500M datasheet lists the waveform as "Stepped approximation to a sinewave", which is a simulated sine wave. That describes the output on battery. On wall power, the UPS passes the utility sine wave through. If you need a sine wave on battery at 1500 VA from APC's Back-UPS Pro range, the BR1500MS2 sheet lists "Sine wave".

Can I run a gaming PC on a BX1500M?

It is not a safe default. Gaming PCs use active PFC power supplies, and some of those shut off on stepped output, more often at high load. The BX1500M is also capped at 900 W. If you already own one, test it: put the PC under a heavy load and pull the UPS plug from the wall. A new purchase for a gaming PC should be the BR1500MS2.

Do the BR1500MS2 and BX1500M use the same battery?

No. APC lists the APCRBC124 cartridge for the BX1500M, a 24 V 9 Ah pack. A reseller listing (APCGuard) gives the APCRBC163 cartridge for the BR1500MS2. Order by the cartridge number for your exact model. The BR is also heavier and runs longer at the same 450 W load, which points to a larger battery.

Why does the BR1500MS2 recharge in 16 hours like the BX1500M if its charger is bigger?

APC rates the BR1500MS2 charger at 16 W and the BX1500M charger at 11 W, but both sheets give a 16 hour typical recharge. A bigger charger filling a bigger battery can take the same time as a smaller charger filling a smaller one. The longer runtime on the BR is consistent with that.

Is the $500,000 equipment protection policy worth the extra money?

Not by itself. The figure is a lifetime ceiling on claims for gear damaged by an electrical event that passes through the UPS. Policies like this carry conditions, such as plugging gear straight into the UPS and keeping your receipt, and they pay repair cost or fair market value. Very few home setups hold $250,000 of equipment on one UPS.

Sources and further reading

  1. APC by Schneider Electric: BR1500MS2 product data sheet (July 7, 2024)
  2. APC by Schneider Electric: BX1500M product data sheet (January 12, 2023)
  3. APC by Schneider Electric: BX1500M product data sheet (October 11, 2024), with replacement battery APCRBC124
  4. Schneider Electric: BR1500MS2 product page and BX1500M product page
  5. Schneider Electric: APCRBC124 replacement battery cartridge (24 V, 9 Ah)
  6. Levata: APC BR1500MS2 specifications (backup time 14.5 min at half load, 4.1 min at full load)
  7. Tanotis: APC BX1500M specifications (runtime 10.9 min at half load)
  8. APCGuard: BR1500MS2 listing and BX1500M listing (prices, outlets, replacement battery)
  9. SmartHomeCompared: BR1500MS2 vs BX1500M (prices)